Remove M5 retaining bolt from the suspension cover with wrench provided. Insert end of spring into suspension bar as diagram. Fit all 3 units. The Platter should now be leveled by adjusting each spring in turn. This is done by holding spring and turning foot as in diagram below. Move the feet so that the springs do not touch the adjusters lower body. The base of the suspension bars should be about 3 - 5mm from the top of foot. Once the motor and drive belt have been fitted readjustment may be required. The suspension will be correctly set when the drive hub is level with the drive pulley and the platter, subchassis and pick-up arm move in a smooth pistonic motion without any wobble. Once correctly set the suspension covers can be refitted so that the suspension bars do not touch.
