HARMAN DIMENSION12
Manual de Usuario

8

Dimension12
SAMPLE BANKS

Dimension12
FRONT PANEL FUNCTIONS

1

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15 16

17

18

19

20

21

When sampling, the capabilities of the D12 are as follows: 4 six second samples, only bank1&2 or 3&4 are playable simultaneously. 2 twelve second samples, only 1 twelve second sample playable at a time. 2 six second samples, and 1 twelve second sample can be stored in memory. Only the 2 six second samples can be played simultaneously. It may be easier to think of bank 1&2 and bank 3&4 as seperate sample groups. Only one �group� can play at a time, whether it is 2 six second samples, or 1 12 second sample. NOTE you must press both banks together to select a 12 second sample. If you have selected a twelve second sample, and accidentally press a single bank button, the sample will be lost. WARRANTY 1. The warranty registration card must be mailed within ten days after purchase date to validate the warranty of this DOD product. 2. DOD warrants this product (1 year parts, 1 year labor ), when used solely within the U.S., to be free from defects in material and workmanship under normal use and service. 3. DOD Electronics liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer, or an authorized DOD sevice center where all parts and labor will be covered up to a period of one (1) year. The company shall not be responsible for any consequential damage as a result of the products use in any circuit or assembly. 4. Proof of date of purchase is considered to be the burden of the consumer. 5. DOD reserves the right to make changes in design or make improvements upon this product without incurring any obligation to install the same on PRODUCTS PREVIOUSLY MANUFACTURED. 6. The foregoing is in lieu of all other warranties, either expressed or implied, and DOD neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product. In no event shall DOD or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control.

1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21.

INPUT LEVEL KNOB controls the amount of signal that enters the D12 RECORD BUTTON engages the record function of the D12 PLAY BUTTON plays the sample in the D12�s currently selected bank STOP BUTTON stops the sample in the D12�s currently selected bank GATE/REVERSE activates the gate or enables sample to be played backwards. In delay mode it engages reverse delay function. STUTTER places a marker in the sample to return to every time the button is pushed DATA WHEEL enables you to find specific points in the sample for easier editing. In delay mode it selects delay time. EDIT BUTTON enables you to place start/stop points within the sample DISPLAY shows a numeric time index of the sample. In delay mode it shows delay time BANK 1 accesses 6 seconds of sampling in bank 1 BANK 2 accesses 6 seconds of sampling in bank 2 Selecting both bank 1 and bank 2 accesses 12 seconds of combined sampling BANK 3 accesses 6 seconds of sampling in bank 3 BANK 4 accesses 6 seconds of sampling in bank 4 Selecting both bank 3 and bank 4 accesses 12 seconds of combined sampling LOOP BUTTON Enables sample to start playing again when it reaches its end point. When engaged the sample will play continuously until button is pressed again. DELAY BUTTON Places D12 in delay mode TAP TEMPO BUTTON Tapping this button in time with the music enables you to set the delay time in time with the music. EFFECT ON/OFF BUTTON Engages the LFO for effects ranging from subtle chorusing to jetlike flanging. SPEED KNOB Controls speed of LFO DEPTH KNOB Controls depth of LFO FEEDBACK KNOB Controls amount of feedback MIX KNOB Blends between dry signal and effect

REAR PANEL FUNCTIONS

1

2

3

4

5

6

7

1. 2. 3. 4. 5. 6. 7.

MIDI IN JACK Plug your MIDI controller in here (optional) FOOTSWITCH INPUT Connect in the DOD FS3M here (optional) A.C. ADAPTER INPUT Connect in the DOD PS750 in here MONITOR OUTPUT Connect to mixer/pre-amp/amp input. MAIN OUTPUT Connect to mixer/pre-amp/amp input. MAIN INPUT (STEREO) Connect output from sample source here MIC INPUT (HI-Z) Connect microphone here