|
|
|
Usuarios conectados
Actualmente hay 5505 visitantes y
3 usuarios online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Section
08
Audio Adjustments
Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select Loud. Press AUDIO until Loud appears in the display. 2 Press a to turn loudness on. Loudness level (e.g., Loud MID) appears in the display. 3 Each press of c or d selects level in the following order: LOW (low)MID (mid)HIGH (high) 4 Press b to turn loudness off. Loud OFF appears in the display. Press c or d to select a desired level.
Adjusting subwoofer settings
When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Press AUDIO to select Sub-W2. Press AUDIO until Sub-W2 appears in the display.
# When the subwoofer output is on, you can select Sub-W2.
2 Press c or d to select cut-off frequency. Each press of c or d selects cut-off frequencies in the following order: 5080125 (Hz) Only frequencies lower than those in the selected range are output from the subwoofer. 3 Press a or b to adjust the output level of the subwoofer. Each press of a or b increases or decreases the level of the subwoofer. +6 6 is displayed as the level is increased or decreased.
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. 1 Press AUDIO to select Sub-W1. Press AUDIO until Sub-W1 appears in the display.
# When the subwoofer controller setting is PREOUT:FULL, you cannot select Sub-W1.
Using non fading output
When the non fading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is output through the RCA output. 1 Press AUDIO to select non fading out-
2
Press a to turn subwoofer output on.
# To turn subwoofer output off, press b.
Sub-W1 Normal appears in the display. Subwoofer output is now on. Press c or d to select the phase of sub-
put on/off setting. Press AUDIO until NonFad ON appears in the display.
# When the subwoofer controller setting is only PREOUT:FULL, you can switch to the non fading output on/off setting. (Refer to page 43.)
3
woofer output. Press c to select reverse phase and Rev. appears in the display. Press d to select normal phase and Normal appears in the display.
2
Press a to turn non fading output on.
# To turn non fading output off, press b.
NonFad ON appears in the display. Non fading output is now on.
38
En
|
|
|
> |
|
