PIONEER DEH-P6750MP/XR/ES
Manual de Usuario

Section

Audio Adjustments

08

Adjusting subwoofer settings

When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer.

2 Press a to turn nonfading output on. NonFad ON appears in the display. Nonfading output is now on.
# To turn nonfading output off, press b.

1 Press AUDIO to select Sub-W2. Press AUDIO until Sub-W2 appears in the dis# You can also select the subwoofer setting menu by pressing SW on the unit. # When the subwoofer output is on, you can select Sub-W2.

Adjusting nonfading output level
When the nonfading output is on, you can adjust the level of nonfading output. 1 Press AUDIO to select nonfading output setting. Press AUDIO until NonFad 0 appears in the display. 2 Press a or b to adjust the nonfading output level. Each press of a or b increases or decreases the level of the nonfading output. +6  6 is displayed as the level is increased or decreased.

play.

2 Press c or d to select cut-off frequency. Each press of c or d selects cut-off frequencies in the following order: 5080125 (Hz) Only frequencies lower than those in the selected range are outputted from the subwoofer. 3 Press a or b to adjust the output level of the subwoofer. Each press of a or b increases or decreases the level of the subwoofer. +6  6 is displayed as the level is increased or decreased.

Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are outputted from the front or rear speakers. 1 Press AUDIO to select HPF. Press AUDIO until HPF appears in the display. 2 Press a to turn high pass filter on. HPF 80 Hz appears in the display. High pass filter is now on.

English

Using nonfading output
When the nonfading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is outputted through the RCA output. 1 Press AUDIO to select nonfading output on/off setting. Press AUDIO until NonFad ON appears in the display.
# When the subwoofer controller setting is only PREOUT:FULL, you can switch to the nonfading output on/off setting. (Refer to page 41.)

# To turn high pass filter off, press b.

3 Press c or d to select cut-off frequency. Each press of c or d selects cut-off frequencies in the following order: 5080125 (Hz)
En

37