PIONEER DEH-1150MPG/XN/ES1
Manual de Usuario

Section

Operating this unit
3 Press a or b to adjust the source volume. SLA +4 to SLA �4 is displayed as the source volume is increased or decreased.
# To return to the normal display, press BAND.

02
Turning the clock display on or off
You can turn the clock display on or off. ! Even when the sources are off, the clock display appears on the display. % Press CLOCK to turn the clock display on or off. Each press of CLOCK turns the clock display on or off.
# The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds.

Other Functions
Adjusting initial settings
Using the initial settings, you can customize various system settings to achieve optimal performance from this unit. 1 Press SOURCE and hold until the unit turns off. 2 Press SOURCE and hold until function name appears in the display. 3 Press FUNCTION to select one of the initial settings. Press FUNCTION repeatedly to switch between the following settings: Clock�FM (FM tuning step)�AM (AM tuning step)�AUX (auxiliary input) Use the following instructions to operate each particular setting.
# To cancel initial settings, press BAND. # You can also cancel initial settings by holding down SOURCE until the unit turns off.

Setting the FM tuning step
The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. ! If seek tuning is performed in 50 kHz steps, stations may be tuned in imprecisely. Tune in the stations with manual tuning or use seek tuning again. 1 Press FUNCTION to select FM. Refer to Adjusting initial settings on this page. 2 Press c or d to select the FM tuning step. Press c to select 50 (50 kHz). Press d to select 100 (100 kHz).

Setting the AM tuning step
The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable). 1 Press FUNCTION to select AM. Refer to Adjusting initial settings on this page. 2 Press c or d to select the AM tuning step. Press c to select 9 (9 kHz). Press d to select 10 (10 kHz).

English

Setting the clock
Use these instructions to set the clock. 1 Press FUNCTION to select clock. Refer to Adjusting initial settings on this page. 2 Press c or d to select the segment of the clock display you wish to set. Pressing c or d will select one segment of the clock display: Hour�Minute 3 Press a or b to put a clock right.

En

11