2-1-3. How to Set the Optical Sensor Disc 1) Fit a lug on the sensor side of optical sensor disc in the hole of the drive.
2-1-4. Precautions on Adjustment 1. Adjustment data The adjustment data for the drive block are recorded to the IC4403 on the MD-114 board. These data cannot be read or written from the adjustment remote commander or SeusCam, unlike the camera and LCD adjustment data. Accordingly, be sure to adjust all items of the drive adjustment when the following parts were replaced: � Drive block � Mounted MD-114 board 2. Order of adjustment Adjust the drive block in the following order: 1) POWER Adjustment 2) DVD-R Adjustment 3) DVD-RW Adjustment 4) DVD+RW Adjustment 3. Precaution on the laser diode
Fit a lug in the hole of drive.
Fig. 6-2-3
2) Push in the optical sensor disc until it clicks in the same manner as when setting a disc.
In the POWER Adjustment, operate the drive with the disc cover left open. During the adjustment, be sure to observe the following precautions: 1) Set the optical sensor disc correctly. 2) Keep the distance of more than 30 cm apart from the camcoder. 3) Work on the LCD screen side of the camcoder (opposite side of the drive). Note: Laser light of the equipment is focused by the object lens in the optical pick-up so that the light focuses on the reflection surface of the disc Therefore, be sure to keep your eyes more then 30 cm apart from the object lens when you check the emission of laser diode