1.Tape Interchangeability Alignment
Note: To do these alignment procedures, make sure that the Tracking Control Circuit is set to the center position every time a tape is loaded or unloaded. (Refer to page 2-3-4, procedure 1-C, step 2.) Equipment required: Dual Trace Oscilloscope VHS Alignment Tape (FL6NS8) Guide Roller Adj. Screwdriver X-Value Adj. Screwdriver Note: Before starting this Mechanical Alignment, do all Electrical Adjustment procedures.
Flowchart of Alignment for tape traveling Loading (Use a blank tape.) Not good Adjust the height of the Guide Rollers (Supply side and take-up side). (Use a blank tape.) (pg. 2-3-3) 1-A
Check to see that the tape is not creasing and that there is no slack on the supply and take-up side Guide Rollers. (Use a blank tape.) 1-A Adjust the X Value for maximum envelope. (pg. 2-3-3) (Use Alignment Tape.) 1-B
Adjust the envelope. (pg. 2-3-4) Check the envelope.
1-C
Not good
1-C
OK Adjust the Audio Section. (Azimuth Alignment) (pg. 2-3-4) Check the audio output.
Do the final tape-traveling test to see that the tape runs normally in play mode without creasing or slacking. 1-A OK
1-D
Not good
Completion
1-D
OK Check the following: 1. X Value (pg. 2-3-3) 2. Envelope (pg. 2-3-4) OK Not good Adjust the X value and envelope. 1-B, 1-C
