WHIRLPOOL CUD4000JQ0
Manual de Usuario

RINSE & HOLD

Use this cycle for rinsing dishes, glasses, and silverware that will not be washed right away.

Do not use detergent with this cycle.

Option Selections
You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

Heated Dry
PreWash Rinse Rinse Main Wash Rinse Final Rinse q Dry Time (min) 20 Water Usage (gal/L) 2.9/10.9

Select this option to dry dishes with heated air. For best drying results, use a liquid rinse aid and heated drying.

q

Canceling a Cycle
You can cancel a cycle at any time. 1. Turn the Cycle Control knob slowly clockwise until you hear water draining. Let the dishwasher drain completely. 2. Open the door. 3. Turn the Cycle Control knob to OFF. NOTE: Heated Dry is an option with all cycles except Rinse & Hold.

No Heat Dry
Select this energy-saving option to dry without heat. No Heat drying is useful when loads contain plastic dinnerware that may be sensitive to high temperatures.

Changing a Cycle or Setting
If your dishwasher has more than one wash cycle, you can change a cycle anytime during a cycle. 1. Lift the door latch to stop the cycle. 2. Turn the Cycle Control knob clockwise. 3. Check the detergent dispensers. They must be filled properly for the new cycle. NOTE: Turning the Cycle Control knob can cause the covered Detergent Dispenser section to open and release the detergent. Check the covered section if the cycle uses detergent in both sections. 4. Close the door firmly until it latches. The dishwasher starts a new cycle.

The dishes take longer to dry and some spotting can occur. For best drying, use a liquid rinse aid. Some items (such as plastics) may need towel drying. IMPORTANT:
s s

Operate your dishwasher only when you are at home. If your home is equipped with a water softener, do not start the dishwasher during the regeneration of the softener.

Adding Items During a Cycle
You can add an item anytime before the main wash starts, or the Cycle Control knob reaches Light Wash. 1. Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door. 2. Open the door and add the item. 3. Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle. 4. Close the door firmly until it latches. The dishwasher resumes the cycle.

Drying System
During drying, you can see steam escaping through the vent at the upper left corner of the door. This is normal as the heat dries your dishes.

IMPORTANT: The vapor is hot. Do not touch the vent during drying.

Overfill Protection Float
The overfill protection float (in the front right corner of the dishwasher tub) keeps the dishwasher from overfilling. It must be in place for the dishwasher to operate.

Check under the float for objects that may keep the protector from moving up or down.

11