PANASONIC CUC12BKP6
Manual de Usuario

HELPFUL INFORMATION
I Auto Operation Button
ECONOMY POWERFUL POWER SLEEP TIMER

ENERGY SAVING AND OPERATION HINTS
I Auto Restart Control � If power is resumed after a power failure, the operation will restart automatically after 3 - 5 1/2 minutes. � Operation will be restarted automatically under the previous operation mode and airflow direction when power is resumed as the operation is not stopped by the remote control. I Timer Setting � When power failure occurs, the timer setting will be cancelled. Once power is resumed, reset the timer. I Thunder and Lightning � This air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner from being damaged by abnormally strong lightning activity, you may switch off the main power supply and unplug from power socket. I Setting the Temperature � Approximately 10% of electricity can be saved. � Set the temperature 2°F higher than the desired temperature. I Air Filters and Air Purifying Filters � Clean the air filters every 2 weeks and the Air Purifying Filters every 6 months. � Dirty filters may reduces cooling efficiency. I Keep All Doors and Windows Closed � Otherwise, cooling performance will be reduced and electricity cost is wasted. I Outdoor Unit � Do not block the air outlet vents. Otherwise, it will lower the cooling performance. I Timer and Sleep Mode � To prevent wastage of electricity, use sleep mode when sleeping or Timer when going out. I Avoid Direct Sunlight � Keep curtains or drapes closed to avoid direct sunlight during cooling operation.

� Raise the front panel and press.
G Automatic Operation � If the remote control fails to function or has been misplaced, press the Auto Operation button to start the Automatic operation. � The Automatic operation will be activated immediately once the Auto operation button is pressed. However, temperature cannot be adjusted in this operation. � The power indicator on the indoor unit will blink until the operation mode is selected automatically. � To cancel this operation, press once more. G Remote Control Signal Receiving Sound � To switch off the beep (Signal Receiving Sound), press the Auto Operation button for 10 seconds continuously or longer. �Beep�, �beep� sound will be heard at the tenth seconds. Note: �Beep� sound will be heard at the fifth seconds; However please press continuously until you heard �beep�, �beep� sound. � Repeat the above steps if you want to switch on the Signal Receiving Sound. G (This is for Servicing purposes only.) Note: If you press this button continuously for 5 to 10 seconds, Test Run operation will be performed. A �beep� sound will be heard at the fifth seconds indicating the Test Run starts to operate.

9