|
No hay comentarios de productos.
L-Board - CRT output Plugs into the socket on the CRT neck. To remove this board, first unplug the board from the CRT neck, then disconnect L1, L2 and L3 connectors, to disconnect the focus F1(red cable) & F2 (white cable) cables from the CRT socker, pull the tab and release the cables (see figure),finally disconnect the screen cable from the DBoard D16 (screen and heater). To reinsert back the cables, remember the original position of cables, F1 (red cable) goes to A on the CRT socket and F2 (white cable) goes to B on the CRT socket. F1 and F2 cables release
To release screen GND cables from L-Board L11 & L12 connectors, insert a wire in both sides of connector and pull upwards the cable, then remove the wire. L11 and L12 cables release
G-Board Mated to A-Board by three flexible connectors A1, A2, A3 and D40 from D-Board. To remove this board, first unplug the four flexible connectors, then RT1 and G4connectors, then pull upwards the board while unlock the tabs from the chassis tray.
Speakers Each speaker is secured to a plastic base with 4 screws, and each plastic base is secured to the from cabinet with two screws. NOTE When reassembling speakers be sure to connect the speaker wires to the correct speaker lead (+) (-)
19
|
