AIWA CSDES155
Manual de Usuario

Power Supply
FUNCTION

BAIT

IMPORTANT Make sure that FUNCTION is set to (!) STANDBY POWER/ TAPE before connecting the AC cord or inserting batteries.

Before connecting the AC cord (LH model only) Check that the rated voltage shown on the rear panel matches your local voltage. To ~jm;.fi= ;~21;match your local voltage, switch the AC VOLTAGE selector (AC 11O-120/220-240 V, AC VOLTAGE switchable) in the battery compartment with
a screwdriver or similar tool.

Connect the AC cord as illustrated

below.

it

+ ~

Q
to an AC outlet

AC VOLTAGE
(LH model only)

CAUTION Use only the supplied AC cord. Use with other cords may result in the risk of fire.

Open the lid of the battery compartment on the rear and insert eight RI 4 (size C) batteries, not supplied, as illustrated below. Then close the lid. c Before using on batteries, disconnect the AC cord from the AC inlet. Battery power is cut off automatically cord is connected. when the

Maintenance
To clean the cabinet Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as qlcohol, benzine or thinner. To clean the heads and tape paths After every 10 hours of use, clean the heads 0 and 0, the pinchroller @ and capstan ~. Use a cotton swab @ slightly moistened with cleaning fluid or denatured alcohol.

o
@
R14 (c)

The batteries need to be replaced when: The OPE/BATT indicator becomes dim, the tape speed slows down, volume decreases, operation.
Notes on batteries

or sound is distorted during To clean the lens Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the c&ter to the edge. Lens

fir+>

To avoid damage from leakage or explosion, observe the following: Insert the batteries with the 0 and ~ marks correctly
q q

>1%

q

q

aligned. Do not mix different types of batteries or old batteries with new ones. Never recharge the batteries, apply heat to them or take them apart. Remove dead batteries. If liquid leaks from the batteries, wipe thoroughly to remove.

2