Setting the clock 1 Press ?/1 to turn on the system. 2 3
Press CLOCK/TIMER SET. Press . or > repeatedly to set the hour. Press ENTER. Press . or > repeatedly to set the minute. Press ENTER.
Getting Started
AM
AM loop antenna Note
4 5 6
To prevent noise pickup, keep the antennas away from the system and other components.
3 Connect the mains lead to mains.
The clock starts working.
If the plug does not fit the wall socket, detach the supplied plug adaptor (only for models equipped with an adaptor). To turn on the system, press ?/1.
To adjust the clock
1 2 3
Press CLOCK/TIMER SET. Press . or > until �CLOCK� appears, then press ENTER. Do the same procedures as step 3 to 6 above.
To attach the speaker pads
Attach the supplied speaker pads to the bottom of the speakers to stabilize the speakers and prevent them from slipping.
Note
The clock is not displayed in Power Saving Mode.
Inserting two R6 (size AA) batteries into the remote
e E e E
Note
If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.
Tip
When the remote no longer operates the system, replace both batteries with new ones.
