MOUNTING COVER ASSEMBLY TO TRACTOR (See Fig. 4) Use Hardware - - GROUP "C"
5
� � �
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor. � Raise seat on tractor to allow assembly to be mounted. � With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket. � Line up holes in mounting bracket with holes in support post and insert bracket support pin. Secure with retainer spring. � Unlatch and open cover. � � Install the three (3) tubing end caps onto container support. Tap each end cap onto container support tubes to seat securely.
COVER ASSEMBLY
Place bottom half inside of top half, as shown. Place one foot inside bottom half and lift top half to meet bottom half. Press halves tightly together while lifting top to lock into place as shown.
CONTAINER ASSEMBLY (See Fig. 5) No hardware required
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN INSET.
�
Repeat for second container.
CONTAINER BOTTOM HALF
BRACKET SUPPORT PIN
CONTAINER TOP HALF CONTAINER BOTTOM HALF RETAINER SPRING
PRESS TOGETHER TO FORM SEAL WHILE LIFTING TOP HALF LOCKING TAB
ASSEMBLY CHECK: Squeeze sides of lower half of container and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
END CAP
tainer Con hen w talled.lace ner. is ns . Rep contai t erly ntly en op pl r is prg frequeacem re ntaineck baded co Che men less n. m un tio co INGmower tieriora a re ly on N eae and de WARoperat r aged. Use not w Do ect to dam bj d or su ke crac
