SECTION 2 DIAL POINTER INSTALLATION
Note : Follow the installation procedure in the numerical order given.
Chassis
Pointer Knob (tune)
MIN
PS
5 Screw (+P 2.6x6)
4 Knob (tune)
(Fig-2)
Notch
3 Pointer
Pointer
2
(Fig-1)
1
Tuner board Chassis PVC shaft
1 Turn the PVC shaft fully counterclockwise. 2 Place the pointer in the chassis groove. 3 Line up the tip of the pointer with the notch in the chassis. (Fig-1) 4 Attach so that the knob (Tune) is at the position show in Fig-2. 5 Fasten the knob (tune) to the PVC shaft with the screw.