SONY CFD-CD777SMK2
Manual de Servicio

CFD-CD777SMK2

Playing a tape
Use these buttons for additional operations

31

2

3

2

DIRECTION hH DIR MODE VOLUME

Level meter

Basic Operations
m, M xZ X m, M X xZ

For hookup instructions, see pages 19 � 20.

1

Set FUNCTION to TAPEÂ¥CD/ RADIO OFF.

Note During playback, do not press M, m or N on the other deck as this causes excessive wow and flutter. Tips ¥ During operation, the level meter shows the frequency level of the sound. Adjusting the volume will not affect the level meter. ¥ To play tapes in both decks successively, press N on

To adjust the volume stop playback fast-forward or rewind the tape pause playback

Do this Turn VOLUME. Press xZ. Press m or M. Press X. Press the button again to resume play after pause. Press down DIRECTION once. DIRECTION h H (reverse/ forward) indicators show the tape direction of deck A. Press xZ.

play the opposite side of the tape (deck A only)

2

Press xZ to open tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment.
With the side you want to play facing you

deck B and then press PLAY and X on deck A as the same time. When the tape ends on deck B, the playback starts automatically on deck A.

eject the cassette

To select the direction of the tape (deck A only)
To play both sides of the tape repeatedly both sides of the tape from the front side to reverse side only* * If play begins from the reverse side, the tape stops at the end of that side. Set DIR MODE to

3

Press PLAY N. The player starts playing.

8GB

9GB

Recording on a tape

2

3
MIC

1

3Deck B

Start recording. Press z on deck B (N is depressed automatically).

1

Press xZ to open the tape compartment on deck B and insert a blank tape. Use TYPE I (normal) tape only. Close the compartment.
With the side you want to record on facing you

Notes ¥ During recording, do not press M, m or PLAY on deck A as this causes excessive wow and flutter. ¥ While recording from the built-in microphone (MIC), no sound comes from the speakers or the headphones. ¥ When you connect the microphone to the MIX MIC jack, you cannot record from the built-in microphone. Tips ¥ Adjusting the volume or selecting the audio emphasis will not affect the recording level. ¥ If the MW program makes a whistling sound after you�ve pressed z in step 3, set the ISS¥FM MODE (Interference Suppress Switch) at the rear to the position that most decreases the noise. ¥ For the best results, use the AC power as a power source. ¥ To erase a recording, proceed as follows: 1 Insert the tape into deck B. 2 Disconnect the audio source if connected to the TV/LINE IN jack at the rear. 3 Set FUNCTION to TV/ LINE IN. 4 Press z on deck B.

Use these buttons for additional operations
xZ X

Basic Operations

n xZ X

To stop recording pause recording

Press xZ on deck B X on deck B Press the button again to resume recording.

2

Select the program source you want to record. To record from the CD player, set FUNCTION to CD and insert a CD.

Display

To record from the radio, set FUNCTION to RADIO, and tune in the station you want using BAND and TUNING. To record from the built-in microphone (MIC), set FUNCTION to TAPEÂ¥CD/RADIO OFF.

10GB

11GB

5