|
No hay comentarios de productos.
Ver 1.1 2000. 06
� NOTE FOR INSTALLATION OF THE �BASE, CHANGER� It is important for the CD changer mechanism to ensure a proper alignment between the �gear, tray� and the �gear, tray rock�.
2 There are two types of �gear, tray� available: screw fastening type and rubber fit type. For the rubber fit type of �gear, tray� , fit the rubber in the boss on the �gear, tray� . Do not allow the rubber to project. Take care not to damage the claw. claw rubber
OK
gear, tray
NG
gear, tray gear (C), relay gear, tray rock
gear
pin base, changer
1 Pass a pin of 1.5 mm diameter through the holes in the �gear , tray � and the �gear, tray rock� and align these holes with the hole in the �base, changer�.
� 11 �
|
