SHARP CDPC651H
Manual de Servicio

SETTING CLOCK RESETTING THE MICROCOMPUTER
Reset microcomputer under the following conditions:

(Main unit operation) Press ON/STAND-BY button to enter the stand-by mode. q To erase all of the stored memory contents (clock and timer

2 1 Press ON/STAND-BY button to enter the stand-by mode. 4 Press TUNING/TIME ( or ) button to select the time
Whilst pressing down button and the second.
(AM 0:00 PM 11:59) STAND-BY

In this example, clock set for q If the display is not correct. 24-hour (0:00) system. Within 5 seconds, press MEMORY/SET button. q If the operation is not correct.

Press the CLOCK button.

1 2 settings, tuner and CD presets).

3
button, hold down the ON/STAND-BY button for at least 1 CLOCK

1,2

2

display mode. "0:00" � The 24-hour display will appear.

ON/ "AM 0:00" � The 12-hour display will appear. TUNING/ TIME ( )

(0:00 23:59)

q The operation explained above will erase all data stored in q Note that this can only be set when the unit is first installed memory including clock timer settings, tuner and CD SET

"AM 12:00" � The 12-hour display will appear. (AM 12:00 PM 11:59) MEMORY/

Caution:

or it has been reset (see page 29). presets.

5 Press the MEMORY/SET button. 6 Press TUNING/TIME ( or ) button to adjust the hour.

q Press the TUNING/TIME ( or ) button once to advance

2 q When the 12-hour display is selected, "AM" will change autoNotes concerning use: the operation becomes erratic. 0.2 6 m minutes. and sensor on the main unit with a soft cloth. (8" 20')

the time by 1 hour. Hold it down to advance continuously. s Remote control

matically to "PM".

7 Press MEMORY/SET button. q Replace batteries the operating distance is reduced or if 8 Press TUNING/TIME ( o r ) button to adjust q Periodically clean transmitter LED on the remote control 3

4 Press TUNING/TIME ( or ) button once advance q Exposing sensor on the main unit to strong light may in1 5

by 1 minute. Hold it down to change time in 5 terfere with operation. Change lighting or the direction of minute intervals. the unit. 1

OPERATION MANUAL

�7�

0:00 AM 12:00 The hour setting will not even if minutes advance q Keep the remote control away from moisture, excessive heat,

"59" to "00". shock, and vibrations.

q The clock starts operating from "0" seconds.

9 Press the MEMORY/SET button. 5

(Seconds are not displayed.)

6

To see the time display:

7

Press the CLOCK button. q The time display will appear for about 5 seconds.

Note: q The clock display will flash on and off at push of the CLOCK button when the AC supply is restored after a power failure occurs or after the AC power lead is disconnected. If this happens, follow procedure below to change the clock time.

8

9

To change the clock time:

xPress the CLOCK button. yWithin 5 seconds, press the MEMORY/SET button. zPerform steps 6 9 above.

To change the time display mode:

xPerform steps 1 2 in the section "RESETTING THE MICRO-

COMPUTER", on page 29.

CD-PC671H/651H

yPerform steps 1 9 above.