AIWA CDC-Z137
Manual de Usuario

BASIC OPERATION, AUDIO AND CLOCK ADJUSTMENT
PWR/ATT SEL Jog dial (PUSH-SOURCE)

1 Press SEL repeatedly to select the mode to be
adjusted. Pressing SEL cycles through the modes. The selected mode�s indicator appears. 2 Turn Jog dial to increase/decrease the level or to select on/off for the selected mode.

Note
Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state.

Aligning the source levels
(Source Level Adjuster)
DSPL TU (TUNER) +/�

Volume may vary each time you change the source mode. In this case, you can align each source mode�s volume to almost the same level.

Turning the unit on/off
� Press PWR/ATT to turn on the unit. The unit also turns on when you insert a CD. � Press and hold PWR/ATT until the unit turns off.

1 Press Jog dial (PUSH-SOURCE) or TU (TUNER)
repeatedly to select the desired mode.

2 Press DSPL while pressing SEL.
�LA 0� appears on the display.

3 Turn Jog dial to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode will be canceled.

Note
Most operations described in this manual require the unit to be turned on before starting the operation, unless explicitly stated otherwise.

Changing the source mode
1 Press Jog dial (PUSH-SOURCE).
Pressing Jog dial (PUSH-SOURCE) cycles through source modes in the following order:

Restoring the factory settings
1 Turn off the unit. 2 Press and hold DSPL until �LA --� appears on the
display.

TUNER (FM1/FM2/FM3/AM1/AM2) � CD* � AUX

�

Note

You can restore the factory settings only for VOL, BASS, TRE, BAL, FAD, and H-BASS, and aligned source volume levels.

* �CD� does not appear in the display when there is no CD in the unit.

Adjusting the volume
1 Turn Jog dial.
VOLUME indicator appears.

Setting the beep tone
1 Turn off the unit. 2 Press and hold SEL until �bEEP� appears on the
display. 3 Turn Jog dial to select on (level indicators appear) or off (level indicators disappear). 4 Press SEL.

Muting the sound
1 Press PWR/ATT briefly.
ATT indicator flashes. To restore volume, briefly press PWR/ATT again.

Adjusting sound
You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/ rear) and H-BASS (high bass).

ENGLISH

2