SHARP CDC1W
Manual de Servicio

CD-C1W,CP-C1W

OPERATION MANUAL
SETTING THE CLOCK
In this example, the clock is set for the 24-hour (0:00) system.

1 2 3 4

Press the ON/STAND-BY button to enter the stand-by mode. Press the CLOCK button. Within 5 seconds, press the MEMORY/SET button. Turn the jog dial to select the time display mode. "0:00" � The 24-hour display will appear. (0:00 - 23:59) "AM 12:00" � The 12-hour display will appear. (AM or PM 12:00 - 11:59) "AM 0:00" � The 12-hour display will appear. (AM or PM 0:00 - 11:59)

MEMORY/ SET ON/STANDBY CLOCK
Jog dial

q Note that this can only be set when the unit is first installed or it has been reset (see page 25).

5 6

Press the MEMORY/SET button. Adjust the hour by turning the jog dial.

q Turn the dial one click to advance the time by 1 hour. Keep turning the dial to advance continuously. q When the 12-hour display is selected, "AM" will change automatically to "PM".

7 8

Press the MEMORY/SET button. Adjust the minutes by turning the jog dial.

2 3 4
0:00 AM 0:00 AM 12:00

q Turn the dial one click to advance the time by 1 minute. Keep turning the dial to advance continuously. q The hour setting will not advance even if minutes advance from "59" to "00".

9

Press the MEMORY/SET button.

q The clock starts operating from "0" seconds. (Seconds are not displayed.) Note: q In the event of a power failure or when the AC power lead is disconnected, the clock display will go out. When the AC power supply is restored, the clock display will flash on and off to indicate the time when the power failure occurred or when the AC power lead was disconnected. If this happens, follow the procedure below to change the clock time.

5 6 7 8 9

To change the clock time:
When the unit is in the stand-by mode: x Press the MEMORY/SET button. y Perform steps 6 - 9 above. When the unit is on: x Press the CLOCK button. y Within 5 seconds, press the MEMORY/SET button. z Perform steps 6 - 9 above.

To see the time display:
Press the CLOCK button. q The time display will appear for about 5 seconds.

To change the time display mode:
x Perform steps 1 - 2 in the section "RESETTING THE MICROCOMPUTER", on page 25. y Perform steps 1 - 9 above.
�6�