SHARP CDBA125
Manual de Servicio

SETTING CLOCK RESETTING THE MICROCOMPUTER
EQUALIZER q To erase all of the stored memory contents (clock and timer (Main unit operation) tem. X-BASS/ settings, tuner and CD presets). DEMO q If the display is not correct.
Reset microcomputer under the following conditions: In this example, clock is set for the 12-hour (AM 12:00) sys-

q If the operation is not correct.

MEMORY/SET
POWER Within 5 seconds, press the MEMORY/SET button. ON/

1
Press ON/STAND-BY button to enter the stand-by mode.

2 Press the CLOCK button. 1 Press ON/STAND-BY button to enter the stand-by mode. 3 2

ON/ BASS/DEMO button, hold down the ON/STAND-BY button for STAND-BY at least 1 second. Press TUNING/TIME ( or ) button to select the time

POWER STAND-BY While pressing down button and the EQUALIZER/X-

4
(AM 12:00 PM 11:59) Caution: TIME (AM 0:00 PM 11:59) memory including clock timer settings, tuner and CD
presets. "0:00" � The 24-hour display will appear.

display mode. q "CLEAR AL" will appear.

CLOCK "AM 12:00" � The 12-hour display will appear. TUNING/

"AM 0:00" � 12-hour display appear. q The operation explained above will erase all data stored in ( ) (0:00 23:59)

q Note that this can only be set when the unit is first installed

or it has been reset (see page 15).

2

5 Press the MEMORY/SET button. 6 Press TUNING/TIME ( or ) button to adjust the hour.

q Press the TUNING/TIME ( or ) button once to advance

the time by 1 hour. Hold it down to advance continuously.

q When the 12-hour display is selected, "AM" will change auto-

matically to "PM".

3

4 minutes.

7 Press the MEMORY/SET button. 8 Press TUNING/TIME ( o r ) button to adjust the

OPERATION MANUAL

�5�

q Press the TUNING/TIME ( or ) button once to advance

q The hour setting will not even if minutes advance from

by 1 minute. Hold it down to change the time in 5 minute intervals. 12:00 AM 0:00

"59" to "00".

q The clock starts operating from "0" second.

9 Press the MEMORY/SET button. 5

(Seconds are not displayed.) And then the clock display will disappear after a few seconds.

To see the time display:

Press the CLOCK button.

q The time display will appear for about 5 seconds.

6

Note: q The clock display will flash on and off at push of the CLOCK button when the AC supply is restored after a power

failure occurs or after the AC power cord is disconnected.

7

If this happens, follow procedure below to change the clock time.

To change the clock time:

8 xPress the CLOCK button. yWithin 5 seconds, press the MEMORY/SET button.

9 zPerform steps 6 9 above.

To change the time display mode:

xPerform steps 1 2 in the section "RESETTING THE

MICROCOMPUTER", on page 15.

CD-BA120/125

yPerform steps 1 9 above.