ALPINE CDA7873R
Manual de Servicio

Installation
Metal plate

3

Slide the CDA-7876RB/CDA-7873R/TDA7588RB/TDA-7587R into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Detachable Front panel

Caution When you install this unit in your car, do not remove the Detachable Front Panel. If the Detachable Front Panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

1
Bracket

Rubber Cap (Included) Hex Bolt (Included) Dashboard

Lock pin

Removal 1 Remove the detachable front panel. Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 3 Pull the unit out, keeping it unlocked as you do so. <JAPANESE CAR> 2

Mounting sleeve (Included) CDA-7876RB/CDA-7873R/TDA-7588RB/TDA-7587R

Slide mounting sleeve from main unit (see "Removal" on this page). Slide the mounting sleeve into the dashboard.

2

Metal Mounting Strap Screw Front frame

�
Hex Nut (M5)

Bolt Stud

Screws (M5 � 8) CDA-7876RB/CDA-7873R/ TDA-7588RB/TDA-7587R (Included)

CDA-7876RB/CDA-7873R/TDA-7588RB/TDA-7587R

When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CDA7876RB/CDA-7873R/TDA-7588RB/TDA-7587R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the head unit with the metal mounting strap (not supplied). Connect all the leads of the CDA-7876RB/CDA-7873R/TDA-7588RB/TDA7587R according to details described in the CONNECTION section.
NOTE For the screw *, provide a proper screw to the chassis installing location.

Mounting Bracket

39-EN