Installing your phone
Installing the base station
Place the base station close enough to the telephone and mains power sockets so that the cables will reach. 1. Connect the output plug of the base adaptor to the adaptor socket on the back of the base unit and the base adaptor to the wall mains supply. 1 2 Warning ! The electrical network is classified as hazardous according to criteria in the standard EN 60-950. The only way to power down this product is to unplug the power supply from the electrical outlet. Ensure the electrical outlet is located close to the apparatus and is always easily accessible. 2. Connect the telephone line cord to the phone socket on the back of the base unit and to the wall phone socket. Warning ! Always use the line cable provided with the product otherwise you may not have a dialling tone. Please take care that the power supply and telephone line are connected to the correct sockets as incorrect placement could damage your equipment. 3. If you have bought a multi-pack product, each extra handset comes with a charger and a charger adaptor. Connect the output plug of the charger adaptor to the adaptor socket on the bottom of the charger. Connect the charger adaptor to the wall mains supply.
Installing and replacing the batteries in the handset
1. Place 2 rechargeable NiMH AAA batteries (included), with the correct polarity, into the battery compartment on the handset.
2.
Slide the battery door firmly into place.
3.
Place the handset on the base unit or the charger and let the batteries continuously charge for 24 hours before using. The handset may get warm during the initial charge. This is normal. On first use it may be necessary to wait for a few minutes before seeing symbols on the display. Warning : The base station must always be plugged into the mains when charging or when in use. Always use rechargeable batteries.
The warranty does not apply to the batteries and any other components which have a limited lifetime or are exposed to wear.
