JVC CA-D401T
Manual de Usuario

English

Basics of Using the CD Player � Normal Play
To Play a Disc �����������������������
1. Prepare the discs.
CD FM /AM TAPE

2. Press the CD �/8 or DISC button (1-3) of the disc you want to play.
AUX

When using the Remote Control, press the £/8 button or the DISC (1 to 3) buttons. The first track of the selected disc will begin playing. The CD Player automatically stops when the playback finishes the last track of the CD. � If these buttons are pressed while the tray is open, the tray is automatically closed and playback starts. Note: If the CD cannot be read correctly (due to scratches etc.), �00 0000� appears on the display. To stop playing the disc, press the 7 button (or the 7/CLEAR button on the Remote Control). To stop playing and removing the disc, press the 0 button for the disc being played. To pause, press the �/8 button (or the £/8 button on the Remote Control). The Disc display will blink. To cancel pause, press the �/8 button again (or press the £/8 button on the Remote Control). Play continues from the point where it was paused.

To Select a Disc, Track Or Passage Within a Track

���

1. Press the DISC button (1-3) for the disc tray containing the track you want to listen to.
�
P. DOWN P. UP

Example: for the third disc, press 3.

2. Press the 4 P.DOWN or ¢ P.UP button to select the track.
The selected track starts playing. Each time you briefly press and release the 4 P.DOWN or ¢ P.UP button, the track changes by one. � Press and release the ¢ P.UP button to go ahead one track at a time. � Press and release the 4 P.DOWN button to go back one track at a time. Holding down the 4 P.DOWN or ¢ P.UP button, during playback, will fast forward/backwards the CD so you can quickly find a particular passage in the selection you are listening to. When using the Remote Control, press the 4 or ¢ button.

or

Locating a Track With the Remote Control Directly ���
Using the number keys on the Remote Control allows you to go directly to the beginning of any track.
DISC DISC

1. Press the DISC button (1-3) for the disc tray containing the track you want to listen to.
� Example: for the third disc, press 3.

DISC

2. Enter the number of the track you want to listen to with the number keys.
2
TIMER

1
CLOCK

3 6 9

4 7
ECHO

5 8
SET

The selected track starts playing. � Example: for track 5, press 5. For track 15, press +10 then 5. For track 20, press +10, then 10. For track 32, press +10 three times, then 2.

� SELECT +

To Change Discs While Playing ��������������
You can replace a CD in a tray not being used, while another CD is playing.

10

10

1. Press the 0 button of the tray not being used.
The tray opens.

2. Replace the disc in the tray. 3. Press the 0 button to close the tray.

14