Raise your tractor mower deck to its highest position. Install the hex bolts, locknuts and acorn nuts through mower deck housing as shown. Tighten all hardware securely. ACORN NUT
DISCHARGE GUARD ACORN NUT LOCKNUT LOCKNUT
MOWER DECK BAFFLE (See Fig. 1) Use Hardware - - GROUP "A"
3
� �
Align mark on seal with mark at cover opening. Work seal into opening so cover sits between flanges of seal.
COVER SEAL (See Fig. 3) No hardware required
ALIGNMENT MARKS
HEX BOLT HEX BOLT COVER SEAL
FIG. 1 FIG. 3
2
NOTE: If your tractor already has four (4) shoulder bolts installed on the rear drawbar, simply hang the mounting bracket, lanced tabs towards bottom, on the bolts. Discard hardware group "B" and disregard the remaining Step 2 instructions.
REAR MOUNTING BRACKET (See Figs. 2A & 2B)
4
� �
SUPPORT POST (See Fig. 4) Use Hardware - - GROUP "C"
CAUTION: Container support is spring loaded and locked to the cover. Handle cover assembly carefully so as not to unlatch the cover from the container support.
Rotate cover assembly onto its side as shown. Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely.
SHOULDER BOLTS
LANCED TABS TOWARD BOTTOM
FIG. 2A If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below.
CARRIAGE BOLTS
Use Hardware - - GROUP "B"
� � Using the four formed holes in the drawbar, install the four shoulder bolts as shown and tighten securely. Hang the mounting bracket, lanced tabs towards bottom, on the bolts.
SUPPORT POST