4. If you make the control unit output alarm signals to external devices and relate them to the alarm signals from the iris cameras or the control unit, connect the devices to ALARM OUT 1 to 8. For example, you can start alarm-related recording by connecting ALARM OUT and a recorder�s alarm input connector.
G8
G7
G
6
G
5
G4
G3
G2
G
1
ALARM OUT
Note: Alarm-related operations and alarm output timing are configurable through the administration PC. (Refer to the installation guide of the administration software.) 5. After removing the power board�s cover, connect the camera power cable to the control unit, as described in the figure.
Note: Connect the power cable and camera power cable after connecting electric locks and LAN cables to the control unit. The cables should be covered to prevent from pulling and pushing.
