SONY BKSR-104
Manual de Servicio

2-1-5. How to Attach the Hard Disk Drive Unit (BKSH-102G)
Notes: 1) The six hard disk drive (HDD) units are installed in the media unit (VSH-1000) when the media unit (VSH-1000) is connected to the media control unit (VSR-1000) and used. 2) A maximum of six HDD units can be installed in a media unit when a media unit (VSH-1000) is connected to the MPEG-2 encoding unit (VST-1000/1000P) and used. 3) Never subject the HDD units to severe shocks. 1. Confirm that the POWER switch of HDD unit is in the OFF position. 2. Remove the four screws and remove the front panel. 3. Remove the two screws and remove the blank panels. Note: Remove the blank panels corresponding to the HDD units to install.

Screws PSW 3�8

Screws B 3�6

Front panel

Screws B 3�6

4. Align the rails of the HDD unit with the guide rails of the unit. 5. Move the top eject lever of the HDD unit in a level. Insert the HDD unit until the eject lever contact the unit with the bottom eject lever opened in the direction shown by arrow 1. 6. Insert the eject levers in the direction of arrow 2 and lock them. (The HDD unit is inserted to its end.)
(Lever in a level)

Guide rail

Rail

Guide rail 2 HDD Unit Power switch 1 Eject lever

Media unit

2-4