General information for installation � The connector panel is inserted into the same slot as the plug-in board (DEC-79 board) installed in the front of SIU-80. � The model label supplied with the connector panel is attached to the chassis to prevent the panel inserting into the incorrect slot when the connector panel replacement and others. w Do not install with turning the power on Touching the power contact portion or the primary winding circuit may cause electric shock. Turn off the power and unplug the appliance from the outlet before installing. Procedures 1. Turn the SIU-80 power off and unplug the appliance from the outlet. 2. Remove the rear blank panel. (Refer to the Installation Manual supplied with the SIU-80.)
3. Attach the model label supplied with the connector panel in the chassis near the slot to install the board. n After the connector panel is inserted into a slot, the model label cannot be seen. 4. Insert the connector panel to the matching slot and fix the panel by the two screws securing the rear blank panel.
SIU-80 Model label Connector panel BVTT 3X6
Connector panel removal 1. Turn the SIU-80 power off and unplug the appliance from the outlet. 2. Remove the two screws installing the connector panel and pull out the connector panel. m � When removing the connector panel, move the connector panel to the right and left until the connection with the mother board is sufficiently loose, then pull out the connector panel gently. � Panels must be held by the plugs of the cables which are connected to the BNC cables.
