SONY BKM-301HD
Manual de Servicio

1-10
Installing the Input Adaptor

Rewriting the Service Mode Status
CN3

8

Adjust the main bracket position. Insert the B block in the CN4001 and the CN4003 on the A board.

You need to rewrite the service mode status so that the input adaptor can accept HD SDI signals. The following shows how to do this.

3

Press the MENU/EXIT and ENTER/SELECT buttons as needed to display �SDI EXIST 0 216� on the screen.
MENU SELECT

B block

1

Press the MENU/EXIT button on the monitor. The main menu appears.
MENU

EXIT MENU
COLOR TEMP ADJ... INPUT CONFIG... SYSTEM CONFIG... SERIAL REMOTE...

ENTER

SDI EXIST

0 216

EXIT

SELECT ENTER

MENU

A board CN4003 CN4001

After Installing the Input Adaptor

2

1 9
Connect the IN/MONITOR OUT plug (BNC connector installed in Step 5) to the IN/OUT (B block connector).

Return the G board installed in Step 5 in �Before Installing the Input Adaptor� to the original location. Lock the board with the two screws.

To go to the service mode, press the DEGAUSS and ENTER/ SELECT buttons at the same time. The service mode status menu appears.
SELECT

4

Using the +/� button, change �0� to �1� in �SDI EXIST 0 216.�

RESET

2

Reconnect the cables removed in Step 3 in �Before Installing the Input Adaptor�. Slide the main bracket back into the unit until it is set in the original place. Insert the fan connector removed in Step 1 in �Before Installing the Input Adaptor� into the monitor connector. Use the screws (12) to install the rear cover of the monitor.
Note

DEGAUSS
BTA 1125 N/S H. SIZE 238 3

ENTER
SDI EXIST 1 216

3

5

Press the DEGAUSS button. The �WRITE� message appears.

10Connect the cable (red/yellow/
black) from the B block fan to the CN 3 connector on the GC board.

You cannot turn on the power unless you connect the fan connector.
Note

DEGAUSS
SDI EXIST 1 216 WRITE

Reinstall the components and cables just as they were before installation was begun.

(Continued)

20

21