DIGITAL TUNER
Changing tuning grid (some versions only)
In North and South America the frequency step between adjacent channels in the AM and FM band are 10 KHz and 100 KHz respectively. In the rest of the world this step is 9 KHz and 50 KHz. Usually the frequency step has been preset in the factory for your area. 1. Check that the set is in the TAPE/OFF position and switched off. 2. To select 9KHz: Simultaneously, press PROG and REPEAT on the set. 3. Switch the set on to TUNER and then release the controls. � To select 10KHz: Repeat steps 1-3 but in step 2, simultaneously, press PROG and TUNING § on the set. � When you tune to radio stations, the display shows tuning in either steps of 9 or 10. � All preset stations will be affected and you may need reprogram the preset stations.
CD PLAYER
English
STOP PLAY�PA USE
CASSET TE RE CORD ER
1 57 5
O
PROG
BA LOW T
SO
FM
UN
AM LW
D CONTR OL CE N
PROG
VOL
TER
REMO SEN TE SOR
TUNE R PRES ET
�
SHUFFL E SEAR CH
�
SHUFFL
E
BAND
REPEAT
D
Playing a CD
1. Select CD source. 2. Press OPEN�CLOSE to open the CD door. � Display: when you open the CD door. 3. Insert a CD or CD-R(W) with the printed side facing up and press OPEN�CLOSE to close the CD door. � Display: as the CD player scans the contents of a CD. The total number of tracks and playing time are then shown. � Display: is shown if the CD R(W) is not finalized. 4. Press PLAY�PAUSE 2; (on the remote control 2;) to start playback. � Display: Current track number and elapsed playing time of the track during CD playback. 5. To interrupt playback press PLAY�PAUSE 2;. Press PLAY�PAUSE 2; again to resume play. � The display freezes and the elapsed playing time flashes when playback is paused. 6. To stop CD playback, press STOP 9 Note: CD play will also stop when: � the CD door is opened; � the CD has reached the end (unless you have selected REPEAT ALL); � you select another source: TAPE / TUNER.
