TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would invalidate the guarantee. PROBLEM � POSSIBLE CAUSE � REMEDY No sound/power � VOLUME not adjusted � Adjust the VOLUME � Headphones connected � Disconnect headphones � Mains lead not securely connected � Connect the mains lead properly Severe radio hum or noise � Electrical interference: set too close to TV, VCR or computer � Increase the distance Poor radio reception � Weak radio signal � FM: Direct the FM telescopic aerial for optimum reception � MW/LW: Turn the set for optimum reception or indication � No CD inserted � Insert a CD � CD badly scratched or dirty � Replace/ clean CD, see CD player and CD handling � Laser lens steamed up � Wait until lens has cleared indication CD-R(W) is blank or the disc is not finalised Use a finalised CD-R(W) CD badly scratched or dirty Replace/ clean CD, see CD player and CD handling
� � � �
The CD skips tracks � CD is damaged or dirty � Replace or clean the CD � SHUFFLE or a programme is active � Switch off SHUFFLE/PROGRAM Poor cassette sound quality � Dust and dirt on the heads, etc. � Clean deck parts etc., see Maintenance � Use of incompatible cassette types (METAL or CHROME) � Only use NORMAL (IEC I) for recording Recording does not work � Cassette tab(s) may be broken � Apply a piece of adhesive tape over the missing tab space Remote control does not function properly � Batteries dead/ incorrectly inserted � Insert (fresh) batteries correctly � Distance/ angle between the set too large � Reduce the distance/ angle
This product complies with the radio interference requirements of the European Union. The type plate is located on the bottom of the set. 13
