PHILIPS AZ1123/96
Manual de Usuario

English
Supplied Accessories
� AC power cord

Controls/Power Supply CAUTION
Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation.

Power Supply
Using AC power WARNING: Always check you have completely switched off the set, before you change or disconnect power supply. 1 Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the AC MAINS~ inlet and the wall socket.The set is now connected and ready for use. To switch the set off completely, withdraw the power cord from the wall socket. Install the unit near the AC outlet and where the AC power plug can be easily reached. Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. The type plate is located on the bottom of the set. � Helpful hints: To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set. 1 2

General Operation/Tuner
General operation
Switching on and off and selecting the function To select your sound source, adjust the Source selector to: CD, FM or MW. To switch off the set, adjust the Source selector to OFF position. Adjusting volume
Adjust the sound with the VOLUME control.

Top/front panels (See 1)
1 Source selector: CD, FM, MW or OFF � selects CD or radio (FM/MW) source of sound � power off switch 2 2; � starts or pauses CD playback §� � selects the next/previous track � fast searches forwards/backwards (press and hold the button) PROG � programs tracks and reviews the program 9 � stops CD playback; � erases a CD program 3 Display � shows the CD functions 4 REPEAT � repeats a track/ CD program/entire CD. 5 SHUFFLE � plays all tracks in random order 6 OPEN�CLOSE � opens/ closes the CD door 7 TUNING � tunes to radio stations 8 VOLUME � adjusts volume level � � �

Power Supply
Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. Batteries (not included) 1 Open the battery door and insert 6 batteries, type R-14, UM-2 or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "�" symbols inside the compartment (See 1). 2 Replace the battery door, making sure the batteries are firmly and correctly in place.The set is now ready to operate. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst: Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. When inserting new batteries, do not try to mix old batteries with the new ones. Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. 3 4 �

Radio reception
1 2 Adjust the Source selector to FM or MW to select your desiredwaveband. Turn TUNING to tune to a station. Helpful hints: � To improve radio reception For FM, extend, incline and turn the telescopic antenna for best reception. Reduce its length if the signal is too strong. For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set.

�

�

Back/bottom panels (See 1)
9 Telescopic antenna � improves FM reception 0 Battery door � open to insert 6 x 1.5V R-14/ UM-2/ C-cells ! p � 3.5 mm stereo headphone socket Helpful hints: The speakers will be muted when headphones are connected to the set. @ AC MAINS~ � inlet for power cord