If you wish to connect hot and cold water supply (Fig.1):
1. Fix the red marked inlet hose at the hot water tap and at the inlet valve with the red filter on the rear side of machine. 2. Fix the other inlet hose at the cold water tap and at the inlet valve with the blue filter on the rear side of the machine. Make sure: a) The connections are tightly fixed b) Do not invert their position (for example: cold fill into hot inlet valve and viceversa).
If you wish to connect only the cold fill follow the below instruction (Fig.2):
1. You need a Y-piece connector.The Y-piece connector can be ordered via our Service Organization or purchased in a specialized hydraulic component store. 2. Fix the Y-piece connector to the cold fill tap. 3. Connect the two inlet valves present on the rear part of the machine to the Ypiece connector using the relative provider hoses. Make sure: All connections are tightly fixed.
Fig.1
Fig.2
Whirlpool is a registered trademark of Whirlpool USA.
