WHIRLPOOL AWM 161
Guía de consulta rápida

CONSUMPTION DATA Temperature Selector (°C) Cotton Cotton Cotton Synthetics Synthetics Delicates Wool Silk 95 60 40 60 40 30 30 30 Load (kg) 4,5 5,0 4,5 2,0 2,0 1,5 1,0 1,0 Water (l) 49 49 44 55 55 60 60 60 Energy (kWh) 1,70 0,95 0,60 0,80 0,60 0,50 0,30 0,30 Approx. Programme Duration (hours : minutes) 2:05 2:20 2:05 1:30 1:20 0:45 0:40 0:50

PROGRAMME CHANGE To select a programme when a cycle has already begun: 1. Switch off the appliance by pressing the �On/Off� button. 2. Select the new programme. 3. Start the programme by pressing the �On/Off� button. END OF WASH CYCLE 1. At the end of the programme the programme selector moves to the stop position. 2. To unload the machine wait for the door to unlock (about 1 minute). 3. Switch off the appliance, open the door and take out the laundry. 4. Close the tap and leave the door ajar to allow the drum to dry out. �

NOTES AND INDICATIONS FOR USE WATER LEVEL It may not be visible as the cycle is optimised for a minimum water consumption without compromising washing results. SPIN SPEED CONTROL Spin speed may be reduced automatically or may even be excluded in the case of small loads with highly absorbent garments (e.g. bathrobes, bathmat). This control avoids cloth and machine damage and excessive vibrations and consequent noise produced by the machine due to load unbalance: by selecting high spin speeds the noise level increases. � MOTOR NOISE The running noises of the new, electronicallycontrolled motor are not the same as the ones you are used to from your old appliance. Don't be surprised - modern technology has a modern sound. CLEANING THE FILTER To ensure an impeccable function of the pump, check the filter regular and clean it if necessary.

Programme

�

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard EN 60456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the �Energy Label� refer to the programme �Cotton 60°C�.

� ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter �Detergents and Additives� in the booklet. 1. Open the tap. 2. Set the programme selector to the desired programme. 3. Turn the temperature selector to the desired temperature. 4. Special options can be selected. 5. Check that the door is well closed and turn on the washing machine by pressing the �On/Off� button. The indicator lights up, indicating that the washing machine is on. SELECT ANY DESIRED OPTION �No spin� button � Excludes spinning from programme, press button. Suitable for delicate laundry. Note: with the �Cotton� and �Synthetics� programmes a short spin cycle is provided in any case, even if the exclusion has been selected, in order to optimize rinsing results. �Rinse Hold� button � The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. � This option is particularly recommended for the programme �Synthetics� or �Delicates�. � This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Terminate the �Rinse Hold� option: � Press the �Rinse Hold� button again; the programme will terminate automatically with the final spin cycle for the present wash programme.

Whirlpool is a registered trademark of Whirlpool USA.

5019 301 10140