PIONEER AVH-P6850DVD/RD
Manual de Usuario

Section

16

Audio Adjustments

Note If you make adjustments, Custom curve is updated.

select reverse phase and REVERSE appears in the display. 4 Touch c or d on the LEVEL setting to adjust the output level of the subwoofer. Each time you touch c or d increases or decreases the level of the subwoofer. +6 to �6 is displayed as the level is increased or decreased. 5 Touch c or d on the FREQUENCY setting to select cut-off frequency. Each time you touch c or d selects cut-off frequencies in the following order: 50Hz�80Hz�125Hz Only frequencies lower than those in the selected range are outputted from the subwoofer.

Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Touch LOUDNESS on the audio function menu. 2 Touch c on the LOUDNESS setting to turn loudness on.
# To turn loudness off, touch d.

3

Touch c or d on the MODE setting to

select a desired level. Each time you touch c or d selects level in the following order: LOW (low)�MID (mid)�HIGH (high)

Using nonfading output
When the nonfading output setting is on, the audio signal does not pass through this unit�s low pass filter (for the subwoofer), but is outputted through the RCA output. 1 Touch NON FADING on the audio function menu.
# When the PREOUT setting in the initial menu is only FULL, you can select NON FADING. (Refer to page 94.)

Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. ! When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Touch SUB WOOFER on the audio function menu.
# When the PREOUT setting in the initial menu is FULL, you cannot select SUB WOOFER.

2 Touch c on the NON FADING setting to turn non fading output on.
# To turn non fading output off, touch d.

2 Touch c on the SUBWOOFER setting to turn subwoofer output on.
# To turn subwoofer output off, touch d.

3

Touch c or d on the PHASE setting to

select the phase of subwoofer output. Touch d to select normal phase and NORMAL appears in the display. Touch c to

3 Touch c or d on the LEVEL setting to adjust the output level of the non fading. Each time you touch c or d increases or decreases the level of the non fading. +6 to �6 is displayed as the level is increased or decreased.

72

En