TEAC AV-H500D
Manual de Usuario

Troubleshooting
In case of trouble with the unit, please take the trouble to look through this chart and see if you can solve the problem yourself before you call your dealer or TEAC service center.

Specifications
When SURROUND is �OFF� Power output . . . 50 W (6�, 1kHz, 0.5% THD) S/N Ratio . . . . . . . . . . . . . . LINE : 85dB (IHF-A) Input Sensitivity/Impedance LINE:200mV/47k� Frequency Response . . . . LINE : 20Hz~60kHz Tone Control. . . . . . . . . BASS : ±10dB (100Hz) TREBLE : ±10dB (10kHz) When SURROUND is �ON� Power output Front : 35 W + 35 W (1kHz, 0.5% THD, 6�) Rear : 35 W + 35 W (1kHz, 0.9% THD, 6�) When Dolby Pro Logic is �ON� Power output Front : 35 W + 35 W (1kHz, 0.5% THD, 6�) Center : 40 W (1kHz, 0.5% THD, 6�) Rear : 35 W + 35 W (1kHz, 0.9% THD, 6�) GENERAL Power Requirement . . . . . . . . . . . . 230V, 50Hz Power Consumption . . . . . . . . . . . . . . . . 150W (at L/R output, 6% over voltage) Dimensions (W x H x D) . . 285 x 132 x 350mm (11-1/4" x 5-3/16" x 13-3/4") Weight (Net) . . . . . . . . . . . . . . 6.6kg(14-9/16lb) Standard Accessory : Remote Control Unit (RC-767) (Batteries are not included) < Design and specifications are subject to change without notice. < The illustrations may differ slightly from production models.

No power e Check the connection to the AC power supply. No sound from speakers. e Check the connection to the speakers. e Adjust the volume. e Pull out the headphones' plug from PHONES jack. e If muting is on, press the MUTING button. e Set the BALANCE control to the center. The sound is noisy. e The unit is too close to a TV set or similar appliances. Install the unit apart from them, or turn them off. Sound cuts off during listening to the music or no sound even though power is ON. e Speaker impedance is less than prescribed for this unit. e Turn the power off and turn it on again. Then reduce the volume. e Use the correct 6 ohm speakers. Low bass response. e Speaker polarity (+/_) is reversed. Check all speakers for correct polarity. No sound from the rear speakers. e Press the SURROUND ON/OFF button. e Check the connection to the speakers.

No sound from the center speaker. e Select "Dolby PRO LOGIC" or "DOLBY 3 STEREO". Press the CENTER MODE button and select NORMAL or WIDE. (See page 34) Remote control does not work. e If the batteries are exhausted, change the batteries. e Use remote control unit within the range (5m/15ft) and point at the front panel. e Clear obstacles between the remote control unit and the main unit. e If a fluorescent light is near the unit, put it off. If normal operation cannot be recovered, unplug the power cord from the outlet and plug it again.

42
ENGLISH