|
|
|
Usuarios conectados
Actualmente hay 5694 visitantes y
1 usuarios online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
3.1.10 REAR PANEL (1) Loosen 7 screws [ L ]. (2) Remove 6 screws [ M ]. (3) Remove 2 screws [ N ]. (4) Raise slightly REAR PANEL upward. (5) Take out the REAR PANEL. NOTE : � Before the rear panel is inserted into the cabinet, release the short-circuit between the [SB] connector (1) pin and (2) pin of the DIGITAL INPUT UNIT. (Refer to "CAUTION AT DISASSEMBLY" on Page 10). � After releasing the short-circuit between the [SB] connectors, do not turn the power on until the rear panel is inserted into the cabinet. � Prior to starting the work, be sure to read the following written instructions on the CAUTION LABEL attached to the REAR PANEL. Prior to starting the work, be sure to read the following written instructions on the CAUTION LABEL attached to the REAR PANEL. UNPLUG THE POWER CORD FROM AC OUTLET BEFORE OPEN THE REAR COVER (PANEL). When the rear cover (panel) is removed, follow "CAUTION AT DISASSEMBLY" procedure in the service manual before plugging the TV's power cord into an AC outlet. Failure to follow the procedure will result in PERMANENT damage to some of the television features. 3.1.11 PARTITION � Take out the REAR PANEL. (1) Pull out the PARTITION back ward. 3.1.12 REAR COVER � Take out the SPEAKER GRILLE. � Take out the FRONT CONTROL BOX. � Take out the SCREEN ASS'Y. (1) Remove 2 screws [ N ]. (2) Remove 2 screws [ O ] from front side. (3) Slightly pull for backside to disengage of the REAR COVER from hooks. (4) Take out the REAR COVER. NOTE : � Because of the large size, at least two persons are recommended for removal and reassemble.
PARTITION
M O N M
REAR PANEL
REAR COVER BRACKET
Fig.6
REAR COVER
BRACKET
O
Fig.7
1-12 (No.52162)
|
|
|
> |
|
