Insert the power plug of the copier to an outlet, turn the power switch to the "ON" position and then perform the following procedure.
Finisher operation check
5. Set the staple cartridge. Open the stapler cover of the finisher and set the staple cartridge in the stapler unit. Insert the cartridge securely until it clicks. Close the stapler cover.
�
Check the operation in the staple mode. Make 10 copies in the staple mode and check that the copies are stapled properly. If the copies are not stapled at this time, use the following procedure to feed staples to the tip.
1. Open the stapler cover of the finisher. 2. Remove the staple cartridge. Raise the staple cartridge release lever of the stapler unit to remove the staple cartridge.
Installation of the finisher is now complete.
3. Close the stapler cover of the finisher and remove the copies. After removing the staple cartridge, close the stapler cover of the finisher. Then remove the copies from the finisher.
4. Check the staple cartridge. Check that the first staple is at the STAPLE TEAR line of the cartridge before setting the cartridge.
� �
If the first staple does not reach the STAPLE TEAR line, pull it to the line. If the first staple protrudes past the STAPLE TEAR line, tear the staples and align the first staple with the line.
