SHARP AR-DE1
Manual de Servicio

2. Put the copier on the desk.
Hold the four knobs of the copier, fit the four tabs of the copier with the four holes of the desk, and place the copier on the desk.

4. Connect the copier and the desk.
Open the desk front cover. Install the connecting plate large to the connecting plate installing position with the four connecting plate fixing screws to fix the copier and the desk. Then cut off the notch sections (at right and left of the copier) in the connecting plate installing section. Install the connecting plate small to the position shown in the figure below with the connecting plate fixing screws (2 pcs. for each) to fix the copier and the desk.
Notch

Fixing screw

Connecting plate small

Notch

3. Remove the lower tray of the copier.
Remove the lower tray of the copier as shown.

Front cover Connecting plate small Fixing screw

Fixing screw

Connecting plate large

5. Install the lower tray of the copier.
Install the lower tray of the copier as shown.

6. Fix the desk to the floor.
Turn the nut of the adjuster which is in the lower section of the desk with a wrench or nippers in the direction of arrow, and adjust and fix the desk on the floor.

Nut Adjuster

3�2