SHARP AR-D27
Manual de Servicio

Connect the connector (white, 4pin) of power supply I/F harness to the I/F connector (white, 4pin) of the main unit. Remove the M4 screw shown in the illustration, insert the circle terminal of ground harness, and it fixes again.

3. AR-MU2

<Parts included>

<3>Reattach the harness cover to its original position and fix it with the removed screw. At this time, ensure that the power supply I/F harness is arranged as shown in the illustration. � Fix the harness securely to the wire saddle.
Screw  Power supply I/F harness

Front mounting plates: Rear mounting plates:  2 pcs.  2 pcs.

Screws (M4x8):  4 pcs.

1) Turn off the main switch of the main unit of the printer. Turn the main switch located on the front side of the main unit to the "OFF" position. Then, remove the power plug of the main unit from the outlet.

"OFF"
2) Put the main unit of the printer on the multi purpose drawer.
Harness cover

<1>Pull out the paper tray of the main unit until it stops and then remove it by lifting both ends of the tray.

Wire saddle

Wire saddle

6) Adjust the position of the paper guides of the upper paper tray of the stand/paper drawer. Refer to "Setting and adjustment" described later. 7) Carry out the off center adjustment.

<2>Hold the main unit of the printer at the positions shown in the illustration and put the main unit on the multi purpose drawer so that the front side and the left side of the main unit are aligned to those of the multi purpose drawer.
Front side

Rear side

Caution: For installation of the main unit, it must be held by two persons and installed without haste.
AR-D28/D27/MU2 UNPACKING AND INSTALLATION

4�4