SHARP AR-D12
Manual de Servicio

· For two tray type

8. Remove the securing fixture for packing the paper feed unit and remove the packing material.
Remove the securing fixture for packing that fixes the paper pressure plate of the tray by rotating it in the direction of the arrow and remove the packing material.

Relay harness for dehumidification heater

Securing fixture for packing Packing material
Cassette relay harness

[Caution] Be sure to remove the securing fixture before turning on the power.

· For one tray type

9. Change the paper size in the tray.
Hold the grip and slide the cassette side plate to adjust it to the paper to be used.
Relay harness for dehumidification heater

Then, fit the rear end plate to the specified size position.
Rear plate

Cassette relay harness

Side plate

Insert the power plug of the copier to the outlet and turn on the main switch of the copier. Then, carry out the following procedure.

7. Attach the rear covers of the copier and the optional paper feed unit.
Attach the rear covers of the copier and the optional paper feed unit using two screws respectively.

10. Load paper into the paper tray.
Do not exceed the maximum height line.

Rear cover

Screws

Rear cover Screws

11. Check for center displacement.

· Set an original on the document glass and copy it using the paper
tray in the copier. Then, copy an original using the attached optional paper feed unit.

· If the center of the copy image from the tray in the copier is different from that of the copy image from the optional paper feed unit, carry out adjustment referring to the service manual. Installation of Paper feed unit is now complete.