SHARP AR207
Manual de Servicio

C. Thermistor
Installation: Check that the thermistor is in contact with the upper heat roller.

(1 )

(A)

(B)

(3)
(2 )

(4) (3)

D. Heater lamp
Assembly: Insert the spring (A) into the hole (B) in the fusing frame.

Disassembly: There are three pawls on the fusing cover. Remove the screws and slide the fusing cover to the right to remove. The heater lamp is fixed on the fusing cover with a screw. Slide the fusing cover to the front and remove the screw, then remove the heater lamp.

(6 ) (9 )
(A) (2) (1) (2) (B)

(5 ) (7 ) (1 0 ) (8 )

(A )
Assembly: Put the paper guide earth spring (A) under the paper guide (B) before fusing.

(8 )

(B ) (C )

Assembly:

Put the fusing harness (A) on the heater lamp (B) as shown in the figure and fix them together. Place the fusing harness inside the rib (C).

AR-162 DISASSEMBLY AND ASSEMBLY � 3