SHARP AJ1800
Manual de Servicio

8) Install the eject guide roller belt to the position shown in the figure below.

<2> E clutch unit
1) 2) 3) 4) 5) Remove the cabinet. Remove the main chassis unit. Remove the eject roller unit. Remove the lock of the left bearing. Remove the E clutch unit.

[Note for assembly] Apply grease to the GRE section.

<4> U roller unit
1) 2) 3) 4) Remove the cabinet. Remove the main chassis unit. Remove the locks of the right and left bearings. Remove the U roller unit.

[Note for assembly] Apply grease to the GRE section. 6) Remove the E clutch gear. 7) Remove the bearing. 8) Remove the E clutch roller. 9) Remove the E clutch spring. 10) Remove the E clutch shaft.

[Note for assembly] Clean the CLN section with absolute alcohol.

GRE GRE 5 4 3 2

<5> U left plate unit
1 GRE
1) Remove the cabinet. 2) 3) 4) 5) Remove the main chassis unit. Remove the U roller unit. Remove the feed roller unit. Remove the screw, and remove the U left plate unit.

[Note for assembly] Check that the end of the E clutch spring extends from the concave section of the E clutch roller. Insert the E clutch spring into the square hole of the F arm.

<3> Feed roller unit
1) 2) 3) 4) Remove the cabinet. Remove the main chassis unit. Remove the lock of the left bearing. Remove the feed roller unit.

[Note for assembly] Apply grease to the GRE section.