TEAC AG-780
Manual de Usuario

Audio Adjustments

Radio Reception Auto Tuning

POWER Button
Press this button to turn the power on. Press it again to turn the system off. 1. Press the TUNER button*. * The TUNER button can also be pressed instead when you want to listen to a station selected last by changing from another source. 2. Select the AM or FM by pressing the BAND selector button. 3. Press the TUNING MODE button to change to MANUAL mode. (The CH indicator disappears from the display). � This button is used to select Tuning or Preset mode. 4. Press the UP or DOWN TUNING/PRESET button (within 0.5 to 2 seconds). The next station broadcasting at a frequency higher or lower than that of the current station is automatically detected and tuned in. � By pressing and holding the TUNING/PRESET button for longer than 2 seconds, it will continue to control.

STANDBY INDICATOR
The indicator lights up in power standby mode and goes out when this unit is turned on.

SPEAKERS Select Buttons
These buttons are used to select speaker system A or B.

BASS/TREBLE Buttons
These two tone buttons (BASS and TREBLE) can be used to obtain a "flat" frequency response or a tone which suits your individual listening preference. The BASS button adjusts low frequencies and the TREBLE button adjusts the high frequencies.

BALANCE Button
This button is used to adjust the balance between the left and right channels. Normally set to the center position.

LOUDNESS Button
This button compensates for the non-linear response of the human ear at low volumes. Set this switch to the OFF position when listening at normal levels. � FM MODE Button Pressing this button alternates between Stereo mode and Mono mode. Stereo If FM stereo broadcast is received, the STEREO indicator lights in the display. Monophonic broadcasts are received in mono. Mono To compensate for weak FM stereo reception, select this mode. Reception will now be forced monaural, reducing unwanted noise.

MUTING Button (on the Remote Control Unit)
Press this to mute (�20 dB) the sound from the speakers and headphones when answering the telephone, etc. To restore the original volume, press the MUTING button again. While muting is engaged, the MUTE indicator will flicker.

� 12 �