PANASONIC AG1340P
Manual de Usuario

3 Select a program number on the TV which you wish to use as the video viewing channel. Then tune in the TV to the picture from the screen being auto tuned or the screen selected with the I and J buttons of the VCR. � During Auto Tuning, the TV program screen does not appear, and the Auto Tuning screen appears instead.
2

If Auto Tuning stops halfway by turning the VCR off, playback or a power failure: 1 Disconnect the mains lead and then reconnect it. 2 Turn off the VCR and then turn it on. � Auto Tuning commences.

AUTO CHANNEL SET PROCEEDING

AUTO TUNING IS COMPLETED.

In some rare cases after tuning the TV to your VCR, interference may be visible on the picture. To get rid of this interference, you can manually adjust the RF output channel a few channels up and down from the current setting. The procedure is described below. 1 Hold down [MENU] for 5 seconds or more. � The VCR display changes as shown below and the VCR picture on the TV displays this pattern.

END

: MENU

END: MENU

To Cancel Auto Tuning MidOperation
Press [MENU] during Auto Tuning. Auto Tuning is cancelled.

To Restart Plug in Auto Tuning
1 Press [EJECT] and remove the video cassette.

Panasonic VCR

2 Keep the I and J buttons on the VCR pressed simultaneously for 3 seconds or more during the VCR on. � The channel displayed on the VCR display disappears for a moment then changes to 2.

END: MENU

2 Enter the desired channel number (US3 or US4) by the I and J buttons. 3()4 3 Press [MENU] to finish the setting mode.

Disappears

2

3 Disconnect the mains lead and then reconnect it. 4 Turn off the VCR and then turn it on. Press [VCR/TV] to select the VCR mode. � Auto Tuning commences.

4 Retune your TV to the new RF channel for the VCR. Note: � Even if the RF output channel has been changed, it is not necessary to perform Auto Tuning.

13

Setting Up

To Change the RF Output Channel