WHIRLPOOL ADP 6746
Guía de consulta rápida

Wash cycle

How to use the appliance
Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

Press the ON / OFF button. Compartment A: With each wash cycle. Compartment B: For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions! Mechanical indicator lamp C. Electric indicator on control panel (if provided).

A

BC

Fill the detergent dispenser

Check the rinse aid level

Check the regeneration salt level

On models with water softener system only. Mechanical indicator lamp D. Electric indicator on control panel (if provided).

Load the racks Close the dishwasher door, turn on the water tap Select a programme

Refer to the dishwasher loading instructions.

The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up. If necessary (and if provided). The corresponding indicator lamp lights up.

Select additional options

�Change programme in progress�

Press the Start button

The selected programme is then memorised (even in the event of power failure).

Press the START button for 2 sec. until the Start indicator lamp switches off. Select another programme and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

Switch off the appliance Turn off the water tap, unload the racks

Only after the START button has switched off: Press the ON / OFF button. All the indicator lamps switch off.

Warning: When the door is opened steam comes out! Unload the appliance, starting from the lower rack.