IGNIS ADL 951/2 WH
Manual de Usuario

5gb94301.fm Page 8 Wednesday, April 10, 2002 5:54 PM

HOW TO FILL THE SALT CONTAINER
From a water hardness category of 2 to 4, before using the dishwasher for the first time, fill the salt container with approximately 2 kg. regeneration salt and add 1lt water (to find out the hardness level of water in your area, contact your local Water Board or check the last bill you received). If the water hardness level does not correspond to position 3 on the selector (factory setting) or if the water hardness level changes: Turn the selector to the correct position: Set the water hardness by turning the selector fitted inside the dishwasher on the left hand internal wall by using a coin. Use the table below to set the dial to the correct setting:
Hardness level 1 soft 2 average 3 medium 4 hard German degrees °dH 0-6 7 - 13 14 - 20 21 - 35 French degrees °fH 0 - 11 12 - 23 24 - 36 37 - 63 mmol/l Clarke scale or English degrees °eH 0 - 7.5 8.8 - 16.3 17.5 - 25.0 26.3 - 43.8 Setting

0,0 - 1,1 1,2 - 2,3 2,4 - 3,6 3,7 - 6,3

1 2 3 4

If the water hardness level falls within category 1 (soft), no salt is required.

How to fill the salt container Warning: Only use regeneration salts for use in domestic dishwashers! Do not fill the salt container with unsuitable substances, such as detergent, as this will cause irreparable damage to the water softener system. 1. Remove the lower rack. 2. Unscrew the cap by turning it counter-clockwise. 3. When first using the dishwasher: fill the salt container to the rim with water (approx. 1 lt.). 4. Fill the salt container to the rim with regeneration salt (using the filler provided) (when filling for the first time use min. 1.5 kg and max. 2 kg) and stir with a spoon handle. 5. Screw the cap back on by turning it clockwise. 6. Fit the lower rack. 7. If regeneration salt is to be added, immediately start a wash programme (rinsing alone is not sufficient) in order to eliminate any residual saline solution straight away and avoid corrosion. Salt level indicator The dishwasher is equipped with an electric or visual salt level indicator (depending on the model installed). Electric indicator (if provided) The salt level indicator lamp on the control panel lights up when the salt container is empty. Visual indicator The float is clearly visible in the cap window when the salt container is full. The float lowers and is no longer visible when the salt container is empty. 8

Black process 45.0° 100.0 LPI