SHARP 61R-WP4H
Manual de Servicio

61R-WP5H 55R-WP5H

2-7. Remove the four screws from the bottom of the screen frame. Put your hand in between the bottom center of the screen frame and the cabinet. Pull out the frame.

2-7

2-8. The angles are secured on the cabinet. The CRT unit�s aluminum diecast section is fixed on these angles. To detach each CRT unit, remove the four screws near the posts at the aluminum die cast section and then pull out the unit upward.
2-8

CRT Unit Top View

RED

GREEN

BLUE

2-8

3-1

3. Detaching the mirror
(Initial setup) » Detach the screen and you will find the mirror secured by wooden fixtures at top and bottom as well as both sides. The top fixture alone is screwed down, whereas the other three fixtures are locked with adhesive and cannot be removed. » The top and side fixtures have grooves in which the mirror is fitted. The bottom fixture has no groove and the mirror is placed just on it. 3-1. Remove the four screws from the top fixture and detach this fixture. 3-2. Hold both ends of the mirror and gradually lift the mirror along the grooves of the side fixtures. Once out of the grooves, pull the mirror toward yourself.
Mirror 3-2 3-2

19