PHILIPS 60PP9701
Manual de Usuario

SETTING THE TV REMOTE TO WORK ACCESSORY DEVICES
DIRECT ACCESS METHOD

N

ow that you have looked up the three-digit Remote Code Number for your brand of accessory device (see page 4546), you are ready to follow the simple steps shown below. Please read through all the steps before beginning.
BEGIN
SATELLITE RECEIVER
AV POWER

1
GUIDE INFO TV VCR PIP CH DN FORMAT UP ACC SOURCE FREEZE SWAP

1

Press and release the correct VCR or ACC(essory) System button. Press and release the center Menu button.

CABLE TV CONVERTER

2

DVD

AUTO

3

Within thirty seconds after releasing the center Menu button, ENTER THE THREE DIGIT CODE NUMBER for the desired device. The remote is now ready to send commands to the accessory.
AV POWER

VCR

STATUS/ EXIT

MENU/ SELECT

4
GUIDE INFO

VOL

CH
MUTE

1
ACC SOURCE FREEZE UP AUTO

2 5 8 0

3 6 9
SURF

2

4

Point the remote at the accessory device. Press the POWER button on the remote to turn the device ON.
STOP

TV TV SWAP

VCR PIP CH DN

4 7
MENU/ SELECT

FORMAT

STATUS/ EXIT

100+
CH

VOL
MUTE

POSITION

PIP

1 1 4 7

2 5 8
100+

3 6 9 0
POSITION SURF SURF PIP

Remember, if this does not work the first time, repeat steps using the same remote code number. If after a second try the remote does not operate your accessory device, and there are more code numbers listed for your brand, use the next listed code number. If after repeated attempts the code number method does not work your accessory device, try the "SEARCH METHOD" shown on the following page.

SMART HELP

3
Note: For TV remote�s equipped with a backlight option, the unit may �blink� or flash as the three-digit Direct Access code numbers are entered on the keypad. (Two blinks indicate a valid code number entry has been accepted; one long blink indicates an invalid code number or the thirty second time interval for entering code numbers has expired.)

45