Mounting
Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm.
Headroom
The distance to any shelves or tops of a cabinet under the hob is to be at least 55 mm.
Fixing
Screw the fixing brackets out to such an extent that they can be turned in under the table top. Tighten the brackets on to the table top with an ordinary screwdriver.
Cut-out measurements
One rectangular hole is sawn out for the hob combination chosen. The depth of the cut-out for any unit is: 490 mm Length of hole = sum of all units` externally measured length, less 20 mm.
Minimum distance to side wall: 150 mm
Minimum distance to rear wall (non flammable material): 50 mm
MIN 55
Reinforcement beams
Mounting of Reinforcement Beams
A reinforcement Beam, with supporting flanges at each end, is included with each two-burner unit. For unit combinations, a reinforcement beam must be used between each unit.
