SHARP 34NWF5H
Manual de Servicio

34N-WF5H

DRESSING THE LEADS
Insert NS. Insert EW �2 Insert GS and dress the leads with no slack. Fold back and bundle the leads. Insert EW Speaker boxe:RSP-Z0109CEZZ x2 Place the speaker boxes in position and tighten the 4 screws. Screw:LX-TZ3096CEFD �4 Tightening torque: 1.17 ±0.19 N-m (12 ±2 kg-cm)

Screw

Screw

Bundle K, GS, EW and NS. Insert GS. Bundle K. Connect K. Connect M. GS SH Bundle M and EW.

Insert the PWB (until securely locked). å Anode clamp: LHLDW1087CEKZ x2 Reposition the anode clamp. Keep the CRT and other leads Connect the anode 10 mm or more away (after connecting the from the anode lead. coating ground lead). Couple the speaker connectors (for both sides).

Remove the pin cover and fit the CRT PWB.

Couple the speaker connectors (for both sides).

The wider side is the positive terminal. Do not confuse the right and left speakers. Their polarities are different from each other.

Connect the coating ground lead (2 points). Dress the speaker leads (for both sides). Catch them at the hooks indicated. GS å Bundle the K and anode leads. SH

Dress the speaker leads (for both sides). Catch them at the hooks indicated. Connect Pu. Insert SH. Connect M. (Keep the M leads tight.) Pu/Mg

Earth å Secure the CA leads at 2 spots. å Secure the AC cord at 2 spots. Place the core between the two wire holders. å Insert the AC cord holder (LHLDK0014PEZZ) into the indicated recess.

10